Honda Goldwing GL1800 Solid Rear Axle Trike Conversion Installation Manual
download Specifications Overall Width: 57.75″ Overall Length: 108″ Overall Length w/EZ-Steer 109.5 Wheel Base: 71″ Extended 4.5″ At Rear Axel Wheel Base w/EZ Steer 72.5″ Load Capacity: 500 Lb Tire...
View Article2009 – Current Harley Davidson Trike Conversion Kit INSTALLATION MANUAL
download 1. Place the motorcycle on the lift. 2. Place a suitable Jack under the Frame of the Motorcycle and tie down securely. 3. Remove Drain Plug from Primary Cover Assembly and drain oil. 4. Slide...
View ArticleHarley Davidson Softail Drive Side Brake System Installation Manual
download Removing The Stock Components Although the PM Drive Side Brake System can be installed with the swing arm bolted to the frame, we recommend removing it for better access as well as repainting....
View ArticleHarley Davidson FL series Electra Glide, Ultra Classic, Road King, Road Glide...
download Remove existing control arm end cap and grind the outside flush. See picture below for reference. The swing arm will drop if both sides are removed at the same time. To ease installation,...
View Article1987 to Current Harley Davidson Softail (FLST Only) Motorcycle Trike...
download Removal of Original Parts Secure and raise motorcycle 9 to 10 inches using a quality motorcycle lift. Remove the following from the vehicle. See OEM manual for detailed instructions. Items to...
View ArticleHARLEY DAVIDSON DYNA REAR STOP/ TAIL/ TURN SIGNAL RELOCATION MANUAL
download PREPARATION NOTE Position the motorcycle upright using a suitable lift or jack. To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before...
View ArticleIndian Rocker Arm End Play Rear Cylinder/ Front Cylinder Installation
download Rear Cylinder 1Rotate the engine so that the rear piston is at Top Dead Center (TDC), compression stroke, so no load is on the valves. 2Using a 3/16″ allen wrench, remove the four screws...
View Article1999-2008 FLHT Series Harley- Davidson Trike Conversion Kit Installation...
download 1. Place the motorcycle on the lift. 2. Place a suitable Jack under the Frame of the Motorcycle and tie down securely. 3. Remove Drain Plug from Primary Cover Assembly and drain oil. 4. Slide...
View ArticleHarley-Davidson Twin Cam 88 S&S Billet Rocker Covers Installation Instructions
download Failure to confirm pushrod/lifter placement before proceeding with installation can result in damage to rocker arm support plates and other parts. With pushrods at lowest point, front piston...
View ArticleHarley Davidson Road Rod Saddle Bag System Kit INSTALLATION Instructions
download Use locktite on all fasteners!! 2. Put bike on lift and place jack under frame. Raise bike to lift rear wheel. 3. If swing arm pivot shaft is drilled and tapped on each end, they need to be...
View Article
More Pages to Explore .....